BYDF32 mobile multipurpose blower product introduction
隔爆型适用用于含有级别为IIA、IIB级温度组别为T1-T4组爆炸性气体混合物，划分危险区域为1区、2区的场所，如化工、炼油、船舶等工厂做通风换气用，防爆标志为dIIBT4。
Flameproof type suitable for containing the level of IIA, IIB and temperature classes for T1-T4 group explosive gas mixture intothe danger zone 2, zone 1, places, such as chemical industry, oil refining, shipbuilding and other factories with ventilation,explosion-proof symbol is dIIBT4.
BYDF32移动式多用风机风机安装说明
BYDF32 mobile multipurpose blower fan installation instructions
1、安装前应详细检查风机是否有损坏变形，如有损坏变形，待修理妥善后，方可进行安装。
1, before installation, check whether there is damage deformation fan, if damaged, deformation, to be properly repaired, can be installed.
2、安装时要注意检查各联接部分有无松动，叶片与风筒间隙应均匀，不得相碰。
2, the installation should pay attention to check the connection part has no loosening, leaf and air gap should be uniform, may not encounter.
3、联接风口管道的重量不应由风机的风筒承受，安装时应另加支撑架。
3, connecting air inlet pipe weight should not be duct fan bearing, the installation of additional support should be frame.
4、在风机风口端必须装集风器，并希望安装防护网。
4, in the fan outlet end must be installed wind collector, and hopes to install protective net.
5、风机底座必须与地基平面自然接合，不得敲打底座强制联接，以防底座变形，安装时应校正机座，加垫铁片，基本保持水平位置，然后拧紧地脚螺栓。
5, fan base must be the foundation of natural bonding plane, do not beat the base force join, to prevent deformation of the base, the installation should be correct stand, plus pad iron, to maintain the level of the basic position, and then tighten the anchor bolts.
6、安装完毕后，必须先进行实验，待运行正常后，才允许正式使用。
6, after installation, you must first experiment, to be operating normally, allowed for official use.
