家具EN581欧洲测试认证，标准EN581要求具体如下：
深圳华威检测提供相关测试认证服务，咨询-5-8
Updates for Furniture Test Standards (2) – EN
家具测试标准更新(2)-EN
户外家具EN581测试报告，
户外家具EN581测试报告，，
椅子EN581测试报告，，
桌子EN581测试报告，
家具EN581测试报告，家具出口欧盟必须做CE认证
深圳华威检测提供EN581测试报告相关测试认证服务：咨询电话QQ
The European pre-standardENVwhich had been used over 9 years for evaluation of the safety and performance requirements for outdoor seating, was finally revised and approved by the Technical Committee CEN/TC 207 “Furniture” into an official European StandardEN
欧洲批准为欧洲正式标准EN
ENsupersedesENVand all CEN members are required to adopt this new standard into their national standards and withdraw the conflicting standards at the latest by October, 2009.
EN取代ENV强制要求所有CEN 成员将此新标准采用为其国家标准，并要求最晚在2009 年10 份之前回收与此标准冲突的其他标准。
Similar to the pre-standard,ENspecifies，the mechanical safety requirements and test methods of outdoor seating for camping, domestic and contract use for adults, without regard to materials, design /construction or manufacturing processes. However,outdoor furniture for severe contract use, and nformation regarding ageing and degradation caused by light, temperature and moisture are not covered by this standard. All test requirements in this standard are evaluated based on use by persons weighing up to 110kg.
与预备标准类似，EN详细说明了供露营，家用及订制成人户外座椅的机械安全要求和测试方法，而不论此类座椅的材料，设计/结构或生产加工过程。然而，标准中并未包含严苛订制用户外家具，以及光照，温度及湿度造成的剥蚀和老化。标准中的所有测试要求均以体重高达110 公斤的人为评估基础。
Compared to the pre-standard, there are significant changes in this newENbut merely as an improvement such that the standard is easier to read and follow. Listed below are some highlights for the changes.
与预备标准相比，新的EN中有重大变更，但这些重大变更只是便于标准的理解和执行的改进。下面列出的是变更中的一些突出点。
Simplify the “General test conditions” such as preliminary preparation, determination of seat and back loading points, application of forces, etc. by referencing toENConditioning period of outdoor seating was changed from the original of one week down to at least 24 hours.
简化“一般测试条件”例如测试前的初步准备，椅座和椅背加载点的确定，力的应用等。可参考EN户外座椅的调节期由原来的一周缩小为至少24 小时。
Similar
to other furniture standards, tests, test sequence and test parameters were illustrated in table format covering test items in the following sequences.
类似于其它家具标准，测试，测试顺序和测试参数以下面的表格的形式说明，其中包含了测试项目。
