化粪池模具具体价格/玻璃钢化粪池钢模具生产制造
泰鼎路桥工程有限公司，多年来，通过不懈努力，创新跨越已成长为集自主研发、制造销售、终端服务为一体，行业侧目的现代科技型企业，在国内与国际行业中享有很高的知名度和美誉度。
一、久不渗漏
One, no leakage for a long time
产品池身利用C30钢筋混凝土、一次成形、密封性好，绝不会产生因
Product pool body using C30 reinforced concrete, once forming, good sealing, will never cause.
地基沉降而引起的断裂破损和池内板结浮渣层现象，
Fracture damage caused by foundation settlement and Ikeuchi Iyui scum layer phenomenon.
彻底解决了砖砌化粪池污染地下水的问题,保证了化粪池可靠性运行和厌氧化粪的功能。
Thoroughly solved the problem of polluted groundwater by brick septic tanks, ensured the reliable operation of septic tanks and the function of dung oxidation dung.
二、抗压强度高
Two. High compressive strength
产品结构设计合理，受压均匀，经多次耐压测验，卡车在上部辗压不沉降，不变形。
The design of the product is reasonable and the pressure is uniform. After many times of pressure test, the truck does not settle and deformation at the top.
三、安装施工方便
Three. Convenient installation and construction
按图纸要求挖好基坑，把玻璃钢化粪池吊入基坑内适当位置，
Dig the foundation pit according to the drawing requirements, and put the fiberglass septic tank into the proper position of the foundation pit.
连接好进出水口，一天内化粪池就可以安装完毕，且施工不受气候影响。
Connecting the inlet and outlet well, the septic tank can be installed within a day, and the construction is not affected by the climate.
四、处理效果好
Four. The treatment effect is good
沉淀池内厌氧生物填料和挂膜填料系统的应用，截留了更多的生物量，
The application of anaerobic biofilm and film packing system in the sedimentation tank blocked more biomass.
污水处理能力比同等容积的传统化粪池提高了一倍以上。
The capacity of sewage treatment is more than doubled than that of conventional septic tanks of the same volume.
五、使用寿命长
Five. Long service life
本产品耐潮湿、耐氧化、高低温无变形，不畏酸碱，正常使用达50年以上。
This product is resistant to moisture, oxidation resistance, high temperature and no deformation, and is not afraid of acid and alkali. It has been used for more than 50 years.
