Uni-body Design for Ultimate Sealing
一体成型机身工艺，高密封设计
Shaft-Direct Drive (Without Gear Box)
轴直接驱动式，不带齿轮箱
Set Bolt
固定螺栓
Adjust Ring for Swing Angle
旋角调整环
V Cup Seal
V型密封
Needle Cap (To be mounted or removed by the set screw)
针帽，可通过固定螺丝进行装卸
Needle Length Std: 140mm Long Needle: 200mm Max.
探针长度，标准：140mm，：200mm
Flat Wand (Option) 110mm (L) 3mm (W)
防护杆（选装），长110mm，宽3mm
Carbide deposited
针表面超硬化处理
|
探针摆动 |
摆动角度5-175° |
|
电机驱动 |
直接驱动式直流电机 |
|
工作电压 |
直流24V |
|
电流 |
250mA |
|
运行温度 |
0-55℃ |
1. Contact Sensor PCS-100 with Needle Assembly
接触式传感器/探头PCS-100以及探针配套装置
Contact sensor PCS-100
l Rotation angle can be set and/or changed flexibly CW or CCW, in the range of 5° to 175°.
可通过设置或者更改旋转方向来调整旋转角度，调整范围为5°到175°.
Setting CW or CCW on the control unit depends on where the sensor/needle is set, and which one could achieve the nearest contact to the tool.
在控制器上操作，并据传感器探针的位置和近被测工具的原则来调整旋转方向
l Contact pressure of needle (speed of needle swing) can be changed in 3 steps by the switch of control unit. The lowest swing speed is ideal for the small dia. of tools. Up to about 0.4mm dia. of tools can be detected.
只需要三步即可在控制器上调整探针的接触压力（探针旋转速度），旋转速度适合测小尺寸的被测工具，最小测量工具尺寸为0.4mm。
l Swing speed of the needle can be selected in several steps. It can help to minimize the cycle time of machining.
探针旋转速度只需要遵循几个步骤操作即可进行选择，这样能有效地缩短机器加工周期
