Akron
Akron Brass Style # 3462 Forestry MonitorProduct ID: #ABM Forestry Bumper Monitor
Standard Features:
• CAN proportional speed joystick control
• Lightweight Pyrolite® construction, 23 lbs. without nozzle
• Integrated and sealed electronics
• Waterproof (IP 67 rated) locking connectors
• Simple “plug and play” installation
• 320° maximum rotation range with stops at +/- 90°
• 135° maximum elevation range with stops at +45° and -20°
• 12V or 24V option
3462 Forestry Bumper Monitor The 300gpm rated monitor is to be an all electric single waterway monitor constructed of lightweight Pyrolite. The monitor shall have cast-in turning vanes in each elbow. The monitor shall have fully enclosed motors and gears with manual overrides for both horizontal and vertical rotation and may be operated simultaneously. The monitor is not to exceed 13 3/16” high and 11 9/16” wide. The vertical travel shall be from 45° below to 90° above horizontal with adjustable stops at -20° and +45°. The horizontal rotation shall be 320° with adjustable stops at ±90°. The control system electronics shall be integrated with the monitor wiring harness. The control system shall use sealed, locking connectors for the monitor and nozzle motors. Two additional sealed, locking connectors shall be supplied for input power/electric valve control and J1939 CAN bus interface. A sealed USB connector shall be provided for updating control system firmware. All electrical connectors shall be minimum IP65 rated. The operator interface shall consist of a CAN bus compatible joystick which will provide up, down, right, left, fog, and stream control of the monitor. The joystick shall have a trigger switch to control an optional electric discharge valve. The monitor shall include a 5’ long power/valve harness and 20’ long CAN joystick harness.
阿克伦黄铜风格＃ 3462林业MonitorProduct ID ： ＃ ABM林业保险杠监视器
标准功能：
•CAN比例控制摇杆
轻量级的稀建设，23磅。无喷嘴
•综合和密封电子
•防水（ IP 67级）锁定连接器
•简单的“即插即用”的安装
• 320°旋转范围与停止在+ / - 90°
• 135°的仰角范围停在+45 °和-20 °
• 12V或24V选项
3462林业保险杠监控300gpm额定显示器是所有电动单水路显示器轻质地幔构造。监视器都投在每个弯头转向叶片。显示器应具有全封闭的电机和齿轮与手动覆盖水平和垂直旋转，并可以同时操作。显示器是不超过13 3/ 16 “高， 11 9/16 ”宽。垂直行程应为45°可调挡在-20 °和+45 °水平低于90°以上。水平旋转为320 °，在± 90 °的可调挡块。该控制系统的电子设备应集成与监视器线束。控制系统应使用密封，锁定连接器，监视器和喷嘴电机。应提供两个额外的密封，锁定连接器，输入功率/电动阀控制和J1939 CAN总线接口。应提供一个密封的USB连接器，控制系统固件更新。所有电气连接器应为IP65等级。操作界面应包括一个CAN总线兼容的操纵杆将提供下，左，右，雾，和流控制显示器。该操纵杆应具有的触发开关，来控制可选的放电阀。显示器应包括一个5英尺长的电源/阀线束和20' CAN操纵杆利用。
