新疆8方洒水车价格

  • 发布时间:2015-04-28 08:16:04,加入时间:2014年07月30日(距今3930天)
  • 地址:中国»湖北»随州:湖北省随州市曾都经济开发区世纪大道77号
  • 公司:湖北润力专用汽车有限公司, 用户等级:普通会员 已认证
  • 联系:万鹏,手机:13886875953 微信:w13886875953 QQ:1275674073
洒水车保养注意事项
   洒水车保养应该注意的事项,很多用户够买了洒水车之后,不知道有哪些地方需要维护、保养的,首先新购买的洒水车保养可以参考《洒水车保养手册》,上面会告诉用户有哪些部件是需要定期检查、更换的。另外,还有一些是保养手册没有提到的地方也需要保养,用户在使用洒水车的时候一定要注意。
洒水车保养注意的事项有哪些是保养手册上没有的呢?主要有以下6方面:
一、洒水车U型螺栓需经常紧固
   洒水车的U型螺栓主要是对洒水车的罐体经行固定,是需要经常紧固的,因为洒水车的水罐与底盘大梁之间垫有一层木胶垫,当洒水车在使用的时候,罐体里面装满水,洒水车底盘的承载量变大,它的U型螺栓就会由于木胶垫被压变形而出现松动的现象,这时就需要拧紧螺栓了,很多用户在购买了洒水车之后不知道U型螺栓需要经常紧固,导致洒水车水罐发生移位。
二、检查洒水车的管道系统
   洒水车的管道系统需要经常检查,看密封性是否完好,是否有漏水的情况,检查洒水车的球阀开关、吸水管道、橡胶垫等部件,这样做的好处是可以防止出现漏水现象,影响洒水车的使用。
三、检查洒水车的水泵
   洒水车的水泵是用支架、螺丝固定在洒水车大梁上,也需要经常的检查,看螺丝是否有松动现象,经常的紧一紧,还要观察洒水车水泵有无漏水的现象,水泵工作的时候有无杂音。
四、检查洒水车的取力器
   洒水车的取力器安装在洒水车的变速箱侧面,通过其输出的动力带动洒水车水泵工作,要经常检查,如果发现有漏油现象,就需要更换密封件了。洒水车的取力器与水泵通过一个小的传送轴连接,也需要经常的检查,如果发现螺丝松了要及时的经行紧固,还要经常的加注黄油,保证其能正常工作。
五、检查洒水车的出水口、进水口
   洒水车的出水口和进水口都要经常检查,进水口磨损严重的要及时更换,有杂物就要及时的清理。
六、洒水车的滤网要经常清洗
   洒水车的滤网安装在洒水车水泵与管道之间,主要是防止杂质进入水泵。很多洒水车用的没多久,洒水车的压力就变小了,通常出现这种情况不是泵的问题,而是滤网没有及时清洗,被堵住了,压力变小了。这时候抽水也慢,洒水的时候也没压力,所以洒水车的滤网一定要及时的清理。
   用户在保养洒水车的时候一定要注意以上事项,以免影响洒水车的性能和使用寿命,而且以上六条都是洒水车保养手册上没有的。润力洒水车专业厂作为全国的东风洒水车厂家,提供的洒水车价格、高清的洒水车图片,各种型号的洒水车报价,欢迎您的来电咨询。
Sprinkler maintenance matters needing attention
Sprinkler maintenance should pay attention to matters, many users buy the sprinkler, don't know what place need maintenance, maintenance, first to buy new sprinkler maintenance can refer to "sprinkler maintenance manual", it will tell users what is need regular inspection, replacement parts.In addition, there are some is the place where maintenance manual does not mention also need maintenance, it is important to note that users in the use of sprinkler.
Sprinkler maintenance matters on what is on maintenance manual­Basically has the following six aspects:
Often, sprinkler U bolt fastening
Sprinkler u-shaped bolt is mainly for sprinkler tank by the fixed line, are often need to tighten, because of the sprinkler tank and chassis girders rubber gasket between the mat with a layer of wood, when the sprinkler is in use, tank filled with water inside, sprinkler chassis carrying quantity is big, it's U bolt will be due to the wooden pads are loosening of compressive deformation and appear, then you need to tighten bolts, many users after buying the sprinkler don't know U bolt fastening, need often lead to sprinkler tank shift.
Second, check the sprinkler piping system
Sprinkler piping system need to check and see if seal is in good condition, whether there is a leak, check sprinkler valve switch, suction pipe, rubber mat etc, the advantage is to prevent leakage phenomenon, affects the use of sprinkler.
Third, check the sprinkler pumps
Sprinkler water pump is in the water sprayer beam with the brackets, screws, also need to often check, to see if the screw loose phenomenon, often tight tight, observe whether water sprayer pump with and without slack phenomenon, working pump with and without noise.
Fourth, check sprinkler take power
Sprinkler take power device installed in the transmission side of sprinkler, through its output power to drive the sprinkler pump work, often should check, if found to have oil leakage phenomenon, is the need to replace the seals.Sprinkler take power and water pump through a small transmission shaft connection, also need to often check, if it is found that the screw is loose to timely after fastening, also often loaded with butter, can ensure the normal work.
5, check the outlet of the water sprayer, water inlet
Sprinkler outlet and inlet should be regularly check, inlet badly worn to timely replacement, have stuff will timely cleaning.
Sixth, the mesh of the sprinkler to often clean
The mesh of the sprinkler installation between sprinkler pump and pipeline, main is to prevent impurities from entering the pump.Many sprinkler didn't take long for sprinkler pressure becomes small, often appear this kind of circumstance is not the problem of the pump, but the screen not timely cleaning, is blocked, the pressure decreases.When sprinkling water pumping are slow, no pressure, so the mesh of sprinkler must timely cleaning.
Users in the maintenance of the sprinkler when must pay attention to the above matters, so as not to affect performance and service life of the sprinkler, and more than six are not even on the sprinkler maintenance manual.Embellish force sprinkler professional factory as one of the country's largest dongfeng sprinkler manufacturers, to provide the latest price, high-definition pictures of sprinkler sprinkler, various types of sprinkler quotation, welcome to inquire.
欲知更多洒水车,洒水车价格,洒水车厂家,新疆洒水车价格,绿化抑尘洒水车,东风5吨洒水车价格,东风8吨洒水车价格,多功能抑尘洒水车,12吨洒水车多少钱,,园林绿化喷洒车,消防洒水车,雾炮式洒水车等系列专用车等详细信息,请拨打:
 
服务热线:138 9997 2899 ,138 8687 5953

联系我时请说明来自志趣网,谢谢!

免责申明:志趣网所展示的信息由用户自行提供,其真实性、合法性、准确性由信息发布人负责。使用本网站的所有用户须接受并遵守法律法规。志趣网不提供任何保证,并不承担任何法律责任。 志趣网建议您交易小心谨慎。