电池外壳设计注意事项
6.1 Pack design
·Battery pack should have sufficient strength and battery should be protected from mechanical shock
·No Sharp edge components should be inside the pack containing the battery.
外壳设计
·电池外壳应有足够的机械强度以保证其内部电芯免受机械撞击。
·外壳内安装电芯的部位不应有锋利的边角。
6.2 PCM design
·The overcharge threshold voltage should not be exceed 4.25V
·The over-discharge threshold voltage should not be lower than 2.3V
·The PCM should have short protection function built inside
保护电路模块设计
·过充的限制电压应小于4.25V
·过放的限制电压应大于2.30V
·保护电路模块应具有短路保护功能。
湖南合一能源科技有限公司，低温电池、低温锂电池、超低温锂电池生产制造专家，更多产品信息详见合一电池工厂网站。
（以上价格仅供参考，具体价格以实际详谈为准。）
