PCS-250 ，PCS-250
深圳市汉斯福特科技有限公司
张工
座机：
手机：
传真：
Q Q:
公司地址：龙华新区大浪街道大浪社区伟达工业园A栋2楼
PCS-100
断刀检测器
破损检测器
破损检测系统
l Uni-body Design for Ultimate Sealing
一体成型机身工艺，高密封设计
l Shaft-Direct Drive (Without Gear Box)
轴直接驱动式，不带齿轮箱
l Set Bolt
固定螺栓
l Adjust Ring for Swing Angle
旋角调整环
l V Cup Seal
-
型密封
l Needle Cap (To be mounted or removed by the set screw)
针帽，可通过固定螺丝进行装卸
l Needle Length Std: 140mm Long Needle: 200mm Max.
探针长度，标准：140mm，：200mm
l Flat Wand (Option) 110mm (L) 3mm (W)
防护杆（选装），长110mm，宽3mm
l Carbide deposited
针表面超硬化处理
1. Contact Sensor PCS-100 with Needle Assembly
接触式传感器/探头PCS-100以及探针配套装置
Contact sensor PCS-100
l Rotation angle can be set and/or changed flexibly CW or CCW, in the range of 5° to 175°.
可通过设置或者更改旋转方向来调整旋转角度，调整范围为5°到175°.
Setting CW or CCW on the control unit depends on where the sensor/needle is set, and which one could achieve the nearest contact to the tool.
在控制器上操作，并据传感器探针的位置和就近被测工具的原则来调整旋转方向
l Contact pressure of needle (speed of needle swing) can be changed in 3 steps by the switch of control unit. The lowest swing speed is ideal for the small dia. of tools. Up to about 0.4mm dia. of tools can be detected.
只需要三步即可在控制器上调整探针的接触压力（探针旋转速度），旋转速度适合测小尺寸的被测工具，最小测量工具尺寸为0.4mm。
l Swing speed of the needle can be selected in several steps. It can help to minimize the cycle time of machining.
探针旋转速度只需要遵循几个步骤操作即可进行选择，这样能有效地缩短机器加工周期
2. Control Unit SCU-100
SCU-100控制单元
OK output
If a tool is detected, OK relay outputs a momentary or latch signal. Green LED illuminates.
当被测件被检测到良好，继电输出一个瞬间信号，绿LED灯亮起。
FAULT output
When a broken tool condition is detected, FAULT relay outputs a momentary or latch signal Red LED illuminates.
当检测到破损件时，瞬间发出一个故障信号，红色LED灯亮起
System Fault
A system Fault signal outputs at Fault relay when
在以下情况会发出系统故障信号：
l The sensor malfunction.
传感器故障
l The sensor direction setting and the CW/CCW switch setting are opposite.
传感器方向设置和正反旋转方向转换设置错反
l There is a short or disconnection at the sensor cable
传感器电缆线短路后者断开
Both Red and Green LED illuminate
此时红绿灯同时亮起
3. Connecting Cable (STD: 5m) with L90 Connector
配有L90接头的电缆线，标准长5m
4. Clamping Collar
夹圈
