成型特
1、无定形料，流动性中等，吸湿大,必须充分干燥,表面要求光泽的塑件须长时间预热干燥80-90度，3小时。
2、宜取高料温，高模温,但料温过高易分解(分解温度为>270度)。对精度较高的塑件,模温宜取50-60度,对高光泽.耐热塑件,模温宜取60-80度。
3、如需解决夹水纹，需提高材料的流动性，采取高料温、高模温，或者改变入水位等方法。
4、如成形耐热级或阻燃级材料，生产3-7天后模具表面会残存塑料分解物，导致模具表面发亮，需对模具及时进行清理，同时模具表面需增加排气位置。
5、强度较高，耐冲击能力强。
专业供应加纤ABS、防火ABS、抗静电ABS、抗紫外线ABS、抗冲击ABS、食品级ABS、耐热级ABS、耐候级ABS、高流动ABS、以及吹塑级ABS、挤出级ABS、透明级ABS等。
本公司长期供应塑胶原料，种类多样化，标准化，技术化，价格合理。发货准，交期准.质量有保障！本公司郑重承诺：诚信经营，质量至上，可為客户提供（物性、报价、UL报告、RoSH标准、SGS检测报告等）敬请来电咨询洽谈！详情请致电：严生（业务经理）。手机；
详细说明：of post, both were called away, the one twenty-five, the other twenty-two; their brief generation became extinct, their short-lived house fell with them; and ‘in these lawless parts and lawless times’— the words are my grandfather’s — their property was stolen or became involved. Many years later, I understand some small recovery to have been made; but at the moment almost the whole means of the family seem to have perished with the young merchants. On the 27th April, eleven days after Hugh Stevenson, twenty-nine before Alan, died David Lillie, the Deacon of the Wrights; so that mother and son were orphaned in one month. Thus, from a few scraps of paper bearing little beyond dates, we construct the outlines of the tragedy that shadowed the cradle of Robert Stevenson.
